UK Tech Forums
TM… doesn’t it stand for Totally My router… and can do with it what I want ;)
So just to update… I decided to take the plunge and run the commands remotely.
ATEMODE=0 and the “internet disconnect” bug is no longer there.
Thanks again for your assistance…. tracking you down was worth it!
You need to login in order to vote
@GRISU!!!
Thanks for the prompt follow-up and @UK Sentinal for forwarding the PM
The router is a US modded TM-1900. Everything has been smooth until the Merlin 3.14 firmware update which is when the “internet disconnect” problem manifested itself
The router is off-site remote so I probably won’t have an opportunity to try the commands for a couple weeks when I’m on-site again. I can SSH into it remotely but seeing that you recommend a full reset, and in case of a disaster scenario, I’d rather make changes locally… with a backup router in hand, just in case ;)
Also, just to follow your “PS”… were those the prompts that showed up when performing the commands? (ie warnings)?
Finally, just copy and pasting from other commands… is it possible to run it all in one command with the “&&”:
nvram set asuscfeATEMODE=0 && nvram set asuscfecommit=1
You need to login in order to vote
Thanks, so we might have to wait.
Hello @Grisu
Coming over from the SNB forum in regards to an internet disconnect issue… noticed your PM privileges have been removed.
In any case, regarding those commands and ATEMODE, can you provide any further insight on resolving that issue.
Much appreciated.
You need to login in order to vote
