I’ve connected the Draytek Vigor back up as the homehub was working fine for a few days, until it updated itself – interestingly my Signal attenuation shows as 0.0 / 0.0 db on the HH not the 39ish that the Asus shown, and the draytek Shows 127db for line attenuation now. I’m assuming they use different algorithms to work it out or its a ridiculous glitch.
The Draytek is running in Modem and Router mode not a bridge (but I can’t connect any wired devices just yet) So I’m running wifi connection, managed to get IPv6 working as the Asus was incompatible with BT / Openreach’s implementation of IPv6 /56 I believe.
I’m fully connected and VLAN is 101, DSL light does the usual blink until its connected and then steady.
Here’s the VLAN TAG page (note it has customer TPID 0x8100 and Service TPID 0x8100 sections, which only one works at a time, I’ve made successful connection using both – the Service VLAN 101 was the default enabled VLAN Tag which according to draytek is the one to use as its BT only firmware once it detects the G.fast Line)
I’ve also got an option for the Modem Code, it connects using either of these and I can’t see any information regarding the correct one or a difference infact if i manually change them. (highlighted in red also)
Attachments:
Bt G.Fast | Draytek Vigor 2766AC | RT-AX82u
i9 10900k @ 5.3GHz | 32GB DDR4 4000MHz CL16 | Aorus Xtreme 3080ti 2100MHz | LG 3840x1600 175Hz | X34a 3440x1440 100Hz |
http://www.3dmark.com/spy/23655081You need to login in order to vote