[harrenkyym]

I’ve tried to, but my RT only finds the DSL if it is wireless. I can have the cable on, but it is like if it wasn’t.

You need to login in order to vote

[harrenkyym]

I just want to add it as a node to place it in my rooftop, as it was a few years ago.

You need to login in order to vote

[harrenkyym]

Hi.

 

Sorry for replying to this post since it’s “solved”.

 

I have two RT-AC68U and a DSL-AC68U. One of my RT is my main router and another one is wired to the main one. Ethernet blackhaul. Everything fine. The problem comes with the DSL. Three years ago I could make it work converting it to an RT. Then I don’t remember what happened and I never could use it again (I think I tried to upgrade the firmware or something like that). So ASUS released the official support to AiMesh for the DSL model and I tried to revert the conversion, to convert the false RT to the DSL. Now I’ve tried EVERYTHING. I’ve flashed, reflashed and I can’t add the node to my working network.

-I’ve tried to use it as a DSL node.

-I’ve tried to use it as an RT node.

-I’ve used official fw, gnuton and merlin (every attempt I tried to change something)

-I’ve tried to connect it by cable (never recognised as connected by cable)

-I’ve set every nvram command stated in this post. I’ve tried to erase the whole nvram but couldn’t make the mtd-erase2 nvram command to work.

I don’t know, I’m desperate. I’ve lost so so so so much hours and days of my life in these two years trying to make it work again…

Right now it is like an RT using this firmware: RT-AC68U_3.0.0.4_386_40558-gc48f410 (the one that allows me to flash the rt fw using the rescue utility, others fail), set like an aimesh node.

It always stops at 1% and shows this message:

Unable to add your AiMesh node RT-AC68U (MAC address) to your AiMesh system due to the following situations. Please check and try again.Someone else is trying to set up an AiMesh system. Please wait 1 minute and try again.
your AiMesh router and node should be within 3 meters of each other during the setup process.
Make sure your AiMesh node is powered on.
Your AiMesh node has been upgraded to AiMesh-supported firmware.
Your AiMesh node has been reset to default
If you want to find another available AiMesh node nearby, please click “Search”.

 

:(

You need to login in order to vote

[Author]

Posts